Package Include:
1 x Manual Switch
1 x User Manual
Introduction:
This manual switch has three pushbuttons UP-STOP-DOWN. Each button has a set
of normally open contacts. You can connect this manual switch to wired
control terminals of the receiver, and then use it to control the DC motor
or the linear actuator.
Product Description:
Three buttons: UP, STOP, DOWN
Work Mode: Momentary
Button diameter: 30 MM
Hole diameter: 22 MM
Each button is equipped with a set NO contacts
Contact material: silver contacts
Contact rated current: 10A
Operating Temperature: -20°C to +70°C
Waterproof case and waterproof connector
Impact-resistant plastic case
IP rating: IP65
Case size: 134 x 68 x 50 mm (5.3 x 2.7 x 2.0 inches)
Suitable for our receivers with wired control terminals, such as model
S1FC-DC
,
S1PF-DC
,
S1PF3-DC
, S1F2-DC, S1FC-AC, and S1F2-AC.
Wiring:
Connect to the receiver S1FC-DC:
1. Connect the positive pole of DC power supply to terminal <+> of the
receiver's input, and connect the negative pole of DC power supply to
terminal <-> of the receiver's input.
2. Connect the manual switch to the receiver's wired control terminals as
follows:
1) Terminal 3 of UP button to <UP> terminal
2) Terminal 3 of DOWN button to <DOWN> terminal
3) Terminal 3 of STOP button to <STOP> terminal
4) Terminal 4 of the UP, DOWN, and STOP buttons to <COM> terminal
3. Connect two wires of the motor or the linear actuator to terminals
<Motor> of the receiver, and you can exchange these two wires to change the
rotating direction of the motor or the moving direction of the linear
actuator.
Connect to the receiver S1PF-DC:
1. Connect the positive pole of DC power supply to terminal <+> of the
receiver's input, and connect the negative pole of DC power supply to
terminal <-> of the receiver's input.
2. Connect the manual switch to the receiver's wired control terminals as
follows:
1) Terminal 3 of UP button to <S1> terminal
2) Terminal 3 of DOWN button to <S2> terminal
3) Terminal 3 of STOP button to <STOP> terminal
4) Terminal 4 of the UP, DOWN, and STOP buttons to <GND> terminal
3. Connect two wires of the motor or the linear actuator to terminals
<Motor> of the receiver, and you can exchange these two wires to change the
rotating direction of the motor or the moving direction of the linear
actuator.
Operation:
1) Press the UP button, motor rotates in positive direction, or linear
actuator extends outward.
2) Press the DOWN button, motor rotates in reversal direction, or linear
actuator inward retracts.
3) Press the STOP button, motor or linear actuator stops.